E36 M3 96-99 | ID1700 | Injector Dynamics | 1700.60.14.14.6

$1,500.00

Connector Type *

Categories: , Tags: , , , , , , , , , , , , , , , ,

Description

ID1700, for BMW E36 M3, 14mm (purple) adapters. Set of 6.

The ID1700 is the most recent offering from the partnership of Injector Dynamics and Bosch Motorsport. The ID1700 was designed to fill the gap between the ID1300 and the ID2000, and like the ID1300, it features corrosion resistant internals making it compatible with all known automotive fuels.

A unique magnetic circuit, resulting from a lengthy development program, makes the ID1700 immune to voltage and pressure sensitivity problems that plague other high impedance high flow injectors. The ID1700 excels at high pressures typical of current automotive systems, and will perform flawlessly in these applications.

Application Notes

The ID1700 was designed to be an all fuel compatible injector, capable of very high flow rates. As such, it will most often be used to deliver E85 to boosted engines, or occasionally, gasoline in extreme high horsepower applications. Neither of these applications requires extended linearity at low flow rates, and so this was given a proportionately lower priority during the design process.

The ID1700 will deliver flawless stoichiometric idle and cruise mixtures on E85, but like the ID2000, should not be expected to do so on gasoline.

If you need flawless drivability on gasoline, the ID1300 will provide this, and is capable of approximately 150hp per injector on E85.

Basic Specifications

  • Length – 60mm, measured from o-ring to o-ring
  • Inlet o-ring – 14mm diameter
  • Outlet o-ring – 14mm diameter
  • Nominal Volumetric Flow Rate – 1725 cc/min at 3.0 bar using gasoline at 52 °C
  • Maximum Differential Fuel Pressure – 7.0 bar
  • Fuel Compatibility – Compatible with all known fuels
  • Electrical Connector – US Car

When ordering, please specify connector preference. You have the option to choose between:

  • Clips & Pins: allow the installer to disassemble the factory connector and re-assemble with the Injector Dynamics (US Car) connector
  • Pigtails: preassembled Injector Dynamics connector with 3″ of unterminated wire to allow cut-and-crimp (or solder) installation.

Technical Support

MoTeC’s professional, race-grade electronics are sophisticated and therefore it is highly recommended that installation is performed by a professional installer. It is NOT advised for the average installer. An advanced understanding of electrical systems is necessary. Fischer Motorsports will support all sales and also offers professional grade wiring harnesses and installation services for all applications. We have 10+ years of professional race experience based upon MoTeC control and specialize in Power train, Chassis, Drivetrain, and Data programming both at our facilities, onsite customer dyno/track support, or even remote support. Please remember that if you cannot find the time or finances to do the job right the first time, you will ultimately end up looking for time or funds to do it over again. Select us or find a qualified installer, it will ultimately increase your results and minimize future expenses or downtime related to improper setup or installation.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.